When you contact the seller, please told him see the information at wpcindustry.com, the seller will give you a discount!
How it works: the mold temperature by the water tank, heating and cooling systems, power transmission systems, liquid level control system and a temperature sensor, an inlet of the injection compositions, and other devices. Under normal circumstances, the power transmission system to pump heat from the fluid reaches the mold is equipped with a built-in heater and a cooler box, then back into the groove from the mold; temperature sensor measuring the thermal fluid and sends the data to the control unit temperature of the thermal fluid regulation controller, thus indirectly regulating the mold temperature controllers. If the chip temperature in production, the die temperature exceeds the set value of the controller, the controller will open the solenoid valve is connected to water, heat the solution until the temperature of the mold the temperature returns to the set value. If the mold temperature is below the set value, the controller will turn on the heater.